
Deck Coating Auckland
A deck takes the same sun and rain as a roof. Total Guard Liquid Membrane Coating seals a solid deck in one seamless, flexible waterproof layer.
Why coat a deck?
A deck sits open to the weather, often over a room, a garage or the framing of the house. When its surface cracks or its joins open, water gets into whatever is underneath, and that damage usually stays hidden until it shows up inside.
Total Guard Liquid Membrane Coating is an elastomeric coating applied wet that cures into a single seamless layer, with no joins or laps for water to work through. It stretches and recovers as the surface expands and contracts through heat, cold and seasonal change.
Signs a deck needs attention
- Cracks or splits in the surface.
- Water sitting in puddles after rain.
- Joins, edges or flashings lifting or coming apart.
- Moss, mould or slippery green patches.
- A faded or worn finish where the sun hits hardest.
- Water stains on the ceiling below.
What the coating brings
- One seamless waterproof layer, with no joins or laps.
- Flexibility: it expands and contracts with the surface through heat and cold.
- UV resistance for New Zealand’s strong sunlight.
- A crack-resistant, highly adhesive finish.
- A low VOC formulation.
- Colour-matched finishes.
Which decks suit Total Guard Liquid Membrane Coating?
A liquid-applied membrane, ours included, needs a solid, continuous surface to bond to. Timber boards laid with gaps between them let water straight through, so no coating can make them waterproof.
Every deck is different, so the first step is always a free inspection. We look at the surface and its condition, then tell you honestly whether Total Guard Liquid Membrane Coating is the right fix, with a written quote and no obligation.
Preparation comes first
A coating is only as good as the surface under it. Coating over dirt, moss or mould causes early failure, so the surface is cleaned before anything else happens. Damaged areas are fixed and a primer goes on so the coating bonds, and only then is Total Guard Liquid Membrane Coating applied.
How the coating goes on
Free Inspection
We look at the surface and its condition and give you a written quote, free and with no obligation.
Clean
Moss, mould, dirt and debris are removed, because coating over contaminants causes early failure.
Repair & Prime
Cracks and failed seals are fixed, then a primer goes on so the coating bonds to the surface.
Membrane Coating
Total Guard Liquid Membrane Coating is applied and cures into one seamless, flexible waterproof layer.
Deck questions
Can you coat my deck?
That depends on its surface and condition. The inspection is free, with a written quote and no obligation, and if coating is not the right answer for your deck we will tell you straight.
Does it cost anything to have my deck looked at?
No. The inspection and written quote are free, there is no callout fee, and our pricing is upfront, with no hidden fees.
What colours are there?
Total Guard Liquid Membrane Coating comes in colour-matched finishes, so it can sit with the colours of your house. We’ll show you the options at quote time.
What does low VOC mean?
VOCs are the solvents that evaporate from many paints and coatings as they dry. A low VOC formulation gives off less of them.
Are you insured?
Yes, fully insured with public liability cover. Documentation is available on request before we begin any work.
Book your free roof inspection
Honest advice on the condition of your roof, with no obligation and no callout fee.
Book a free inspection Call 022 066 7458